This guide lets you customise the tables used in National Network Map, Network Management and Road Management so you can see the information that matters most to you. You can add or remove columns, change their order, apply filters to narrow down the list, and save commonly used filter sets as named views for quick reuse.

NHVR Portal account with Road Manager access.

Access to the relevant area in NHVR Go (for example Access management > Vehicle networks or Road Management tables).

The table you want to work with is open on screen.

Date of last review: [13 02 2026]

1. Open NHVR Go in your browser and log in with your Road Manager account.

2. Navigate to the table you want to configure (for example the Vehicle networks table under Access management).

3. Review the table and identify which columns you need to see for your task (for example network name, instrument name, Network ID, status).
​
4. Configure the columns for your current view:

a) Choose which columns you want to display, based on the options available for that table and view.

b) Drag and drop the column headings to change the order of columns so the most important information appears first.

5. Apply filters to narrow down the list in the table:

a) Use the filter controls provided in the table (for example filters at the top or top-right of the table).

b) Enter your filter values (for example a part of the vehicle network name, instrument name, or Network ID).

c) Apply the filters and confirm the table now shows only the entries that match.

6. If you expect to reuse this filtered setup often, save it as a view:

a) With your preferred columns and filters applied, use the Manage views or equivalent table view option.

b) Save the current table configuration as a named view so you can quickly return to it later.

7. Use the views management options when you need to switch or update views:

a) Select a saved view to instantly re-apply its columns and filters.

b) Rename or remove saved views that are no longer required.

The set of available columns can change depending on which table and view you are using; if you cannot find a column, check that you are in the correct view for your task.

If the table looks cluttered, hide columns that you do not need for the current piece of work and move key columns (such as network name or Network ID) to the left using drag-and-drop.

Filters are cumulative – if you are not seeing expected results, review each active filter and clear or adjust them before searching again.

Use saved views for filters you run regularly (for example all networks in a particular jurisdiction) so you do not need to rebuild the same filters each time.

If a saved view no longer makes sense (for example after changes to networks or roads), update its filters or delete it and create a new view.

Check your organisation’s internal guidance for any standard views your team uses (for example preferred reporting or review views).

If you cannot configure a table or manage views as expected, contact the NHVR using your usual support channels.